Description
This Momentary Tactile Push Button Module DC 5V 12V Switch is ideally suited to add a button to your projects and gives a high signal when it is pressed. The module of the push button is a fully-fledged device with which you can install it immediately in the project, without using a pull-up or tightening resistances, because this is already in the circuit. The button together with the resistor is located on the board, where there are holes for installation. The built-in resistor has a rating of 10 k. The module is designed for two contacts: when pressed, they are closed and open when released. There are 3 outputs on the board: I, S, + 5V. Contact I is connected to the common wire of the circuit, S is the output of the module and + 5V is connected to the power supply.
Specifications
- Weight: 1gm (approx).
- Dimension: 20mm x 16mm x 7mm.
- Operating Voltage: 5VDC.
- Contact Resistance: 50 MΩ.
- Operating Temperature Range: -25 to 105°C.
- Mech & Electrical Lifecycle: 100,000.
- PCB Thickness: 1.5 mm.
Reviews
There are no reviews yet.